Libratone Support


Classic Loop BT - Factory Reset

To clear all speaker settings on your Libratone speaker you need to perform a factory reset.

Press the three buttons (the two rear buttons on the back panel and the Logo Button) simultaneously.
Keep the pressure for approx. 3 secs until the Logo Button LED starts blinking WHITE or BLUE.

After approx. 30 seconds the LED will change to WHITE BLINK-PULSE-BLINK SEQUENCE, and your speaker is now factory reset.

If you wish to continue with AirPlay setup please click here to the reach speaker setup pages.

Was this article helpful?
0 out of 1 found this helpful