Libratone Support

Follow

ONE/TOO - Bluetooth setup

Our new GO speakers come with Bluetooth setup mode activated out of the box. Setup mode is signaled by side-to-side blinking on the Touch Interface. 

To create a Bluetooth pairing, simply enable Bluetooth on your smartphone or computer and select your speaker in the list of available Bluetooth devices.

When the speaker is successfully connected via Bluetooth, a double blink will occur in the Nightingale.

Note: If you need to manually activate Bluetooth setup mode, press and hold the Nightingale until you see a left - right - left blinking light. 

Was this article helpful?
0 out of 1 found this helpful

Comments