Libratone Support

Follow

ONE/TOO - How to activate Bluetooth setup mode

All new Libratone speakers have Bluetooth setup mode activated out of the box.

If you want to activate setup mode manually at a later point, follow these steps:

  1. Press and hold the Nightingale, located on the Touch Interface of your speaker, for about 3 seconds until you hear an audio cue.
  2. Within 5 seconds, you will see a side-to-side blinking signal on the Touch Interface, indicating that the speaker is in setup mode and ready to be connected via Bluetooth.

Note: Your GO speakers will stay in setup mode for 5 minutes. If the speaker is not set up within 5 minutes, the speaker will fall back to its previous connection.

 

Was this article helpful?
2 out of 4 found this helpful

Comments