Libratone Support


On-Ear - How To Activate Bluetooth Setup Mode

All new Q Adapt On-Ear headphones have Bluetooth Setup Mode activated out of the box.

If you want to activate Setup Mode at a later point, please follow these steps:

  1. Press and hold the Function Button, located on the right side of your headphones, for about 3 seconds until you hear an audio cue.
  2. Within 5 seconds, you will see a side-to-side blinking signal on the Touch Interface, indicating that your headphones are in Setup mode and ready to be connected via Bluetooth.

Note: Your headphones will stay in Setup Mode for 5 minutes. If setup is not completed within 5 minutes, the headphone will fall back to its previous connection.

Was this article helpful?
0 out of 0 found this helpful